Hitachi 32HBT41 Instruction Manual page 3

5
HDMI input
PLEASE ENSURE BOTH UNITS ARE SWITCHED OFF
BEFORE CONNECTING. Use a HDMI to HDMI cable to
connect the two units together. To select the HDMI input,
press the Source button on the remote control. Each time it is
pressed the on-screen menu confirms your selection.
* The appearance of the Source button may differ depending on the
model of the remote control
6
Auto Setup procedure (depending on the model)
When the TV is operated for the first time, installation wizard will guide you through the process.
First, language selection screen will be displayed. Select the desired language and press OK.
On the following screens, set your preferences using the directional buttons.
About Selecting Broadcast Type
Digital Aerial: If this broadcast search option is turned on, the TV will search for digital terrestrial
broadcasts after other initial settings are completed.
Digital Cable: If this broadcast search option is turned on, the TV will search for digital cable
broadcasts after other initial settings are completed. According to your other preferences a
confirmation message may be displayed before starting to search. Select Yes and press OK to
proceed. To cancel operation, select No and press OK. You can select Network or set values such
as Frequency, Network ID and Search Step. When finished, press OK button.
Note: Searching duration will change depending on the selected Search Step.
Satellite: If Satellite broadcast search option is turned on, the TV will search for digital satellite
broadcasts after other initial settings are completed. Before satellite search is performed some
settings should be made. Antenna Type menu will be displayed first. You can select Antenna Type
as Direct, Single Satellite Cable or DiSEqC switch by using directional buttons.
Analogue: If Analogue broadcast search option is turned on, the TV will search for analogue
broadcasts after other initial settings are completed.
Additionally you can set a broadcast type as your favourite one. Priority will be given to the selected
broadcast type during the search process and the channels of it will be listed on the top of the
channel list. When finished, press OK to continue.
You can activate Store Mode option at this point. This option is intended only for store use. It is
recommended to select Home Mode for home use.
Press OK button on the remote control to continue and the Network/Internet Settings menu will be
displayed. Please refer to the next section about internet connection on the next page to configure a
wired or a wireless connection. After the settings are completed press OK button to continue.
After the initial settings are completed TV will start to search for available broadcasts of the selected
broadcast types.
After all the available stations are stored, scan results will be displayed. Press OK to continue. The
Edit Channel List menu will be displayed next. You can edit the channel list according to your
preferences or press the Menu button to quit and watch TV.
Note: Do not turn off the TV while initializing first time installation.
To HDMI connection
SOURCE SOURCE
on the device