Power Management; Ecology; Identifi Cation; Picture Size Settings - Sharp LC-32G100H Operation Manual

Watching TV

Power Management

You can set the TV to automatically power off when no
image is displayed on PC.
Press MENU and the MENU screen displays.
1
Press c / d to select "Power Control".
2
Press a / b to select "Power Management",
3
and then press ENTER.
Press c / d to select "On" or "Off", and then
4
press ENTER.
On
NOTE
• After setting the Energy Save mode to "On", if no signal is
input for about 8 minutes, the power will be turned off.
• Even if you start using the PC and the signal inputs again,
the TV stays off.
• The TV turns on again by pressing POWER. (See page 13.)
• 5 minutes before the power turns off, the remaining time is
displayed at one-minute intervals.

Ecology

When set to "Yes", the TV activates the following
power saving mode.
• "Standby Mode" set to "Mode 2" (Page 24)
• "No Signal Off" set to "Enable" (Page 26)
• "No Operation Off" set to "3 hr." (Page 26)
• "Power Management" set to "On" (Page 27)
Press MENU and the MENU screen displays.
1
Press c / d to select "Power Control".
2
Press a / b to select "Ecology", and then
3
press ENTER.
Press c / d to select "Yes", and then press
4
ENTER.
NOTE
• Ecology mode cannot be deactivated by selecting "No".
Each setting must be changed individually to deactivate
Ecology mode.
Identifi cation
The software version can be look over.

Picture size settings

Selecting the Wide Screen Signalling
(WSS) picture size automatically
WSS allows a television to switch automatically among
the different screen formats.
1
2
3
4
Off
• Try to set WIDE mode if an image does not switch to the
correct screen format. When the broadcast signal contains
no WSS information, the function will not work even if
enabled.
• When receiving weak or unstable signals and for avoiding
wrong estimation of the signals, it is recommended to set
WSS to "Off".
Selecting the Wide Screen Signalling
(WSS) picture size manually
The WSS signal has 4:3 auto-switching that allows you
to select between Panorama and Normal.
1
2
3
4
4:3 mode "Panorama"
Selected item
Panorama
Normal
Press MENU and the MENU screen displays.
Press c / d to select "Setup".
Press a / b to select "WSS", and then press
ENTER.
Press c / d to select "On" or "Off", and then
press ENTER.
NOTE
Press MENU and the MENU screen displays.
Press c / d to select "Setup".
Press a / b to select "4:3 Mode", and then
press ENTER.
Press c / d to select "Panorama" or "Normal",
and then press ENTER.
WSS signal 4:3 screen
Wide image without side bars
Normal range keeping 4:3 or 16:9 aspect
ratio
4:3 mode "Normal"
Description
27