Table of Contents
Advertisement
A S S E M B L Y I N S T R U C T I O N S
Remove the XM2500, crank handle assembly and hex wrench from the packaging.
1. Place the Crank Handle assembly
onto the D-shaped roller shaft
with the set screw facing upward.
2. Move the handle forward on the
D-shaped shaft until it stops.
3. Use the Hex wrench to secure
the set screw.
L O A D I N G S U P P L Y R O L L S
Step 1:
• Remove the top cover of the machine
by lifting upward
• Grasp the handle on the lower access
door; pull to open.
Step 2:
• Match the colored end of each
supply roll with the corresponding
dots on the side of the machine.
Note which roll is identified as
"top" and "bottom".
• Slide the supply rolls into the grooves
in the sides of the machine, making
certain that the roll is inserted
completely.
Advertisement
Table of Contents
