Aiwa HV-GX950 Service Manual page 8

www.freeservicemanuals.info
2-15: AHC ASS'Y/CYLINDER UNIT ASS'Y
(Refer to Fig. 2-15)
Unlock the support 1 and remove the AHC Ass'y.
1.
Remove the 3 screws 2.
2.
3. Remove the Cylinder Unit Ass'y.
NOTE
When you install the Cylinder Unit Ass'y, tighten the
screws from (1) to (3) in order while pulling the Ass'y
toward the left front direction.
Cylinder Unit Ass'y
2
(2)
• Screw Torque: 5 ± 0.5kgf•cm
2-16: CAPSTAN DD UNIT (Refer to Fig. 2-16)
1. Remove the Capstan Belt.
Remove the 3 screws 1.
2.
3. Remove the Capstan DD Unit.
• Screw Torque: 5 ± 0.5kgf•cm
2-17: MIDDLE GEAR/MAIN CAM (Refer to Fig. 2-17-A)
Remove the Polyslider Washer 1, then remove the
1.
Middle Gear.
2. Remove the E-Ring, then remove the Main Cam, Link
Lever Spacer and P5 Cam.
Remove the Polyslider Washer 2, then remove the
3.
Pinch Roller Cam.
Remove the Polyslider Washer 3, then remove the
4.
Joint Gear.
DISASSEMBLY INSTRUCTIONS
2
(3)
AHC Ass'y
1
2
(1)
Fig. 2-15
Capstan Belt
Capstan DD Unit
1
1
1
Fig. 2-16
Pinch Roller Cam
NOTE
When you install the Pinch Roller Cam, P5 Cam and Main
Cam, align each marker. (Refer to Fig. 2-17-B)
Check the hole of Main
Chassis can be seen.
2-18: CLUTCH ASS'Y (Refer to Fig. 2-18)
Remove the Polyslider Washer 1.
1.
2. Remove the Clutch Ass'y, Ring Spring, Ring Clutch,
Gear Clutch and Polyslider Washer 2.
NOTE
When you install the Clutch Ass'y, oil the shaft (KYODO
OIL Slidas #150).
Gear Clutch
B2-4
Digitized in Heiloo, Holland
1
Middle Gear
E-Ring
Main Cam
2
3
Link Lever Spacer
P5 Cam
Pinch Roller Cam
P5 Cam
Main Cam
Marker
1
Clutch Ass'y
Ring Spring
Ring Clutch
2
18/1/2015
Joint Gear
Fig. 2-17-A
Fig. 2-17-B
App. 5mm
Fig. 2-18