Product Specifications; For Your Safety - Airtel STB User Manual

31

Product Specifications

System
Signal format system PAL B/G
Interfaces
Input F type – Connector
Video out IEC 48B sec 316 (RCA) female Yellow
Audio out IEC 48B sec 316 (RCA) female, Left: White, Right: Red
RF out VHF (channel 3/4)
RF
Input frequency range 950 ~ 2150 MHZ
Input Impedance 75 ohm
Power
STB input Voltage DC 12V
Power Supply AC 70 ~ 350 Volts @ 45 to 60 Hz, adaptor
Power Consumption Full load max: 25 W
Mains 2 pin plug
General
Dimension 270 X 200 X 50 (mm)
Weight
Audio & Video cable Both side Male RCA, 1.8 meter in length
RF Cable Both side Male connector, 1.5 meter in length
Remote control TV Learning STB Remote
Batteries for Remote 2 AAA size (Zinc)

For your Safety

This Set Top Box has been manufactured to meet international safety
standards. However you must take care to operate it safely. It is
therefore important that you read these safety instructions and in
case you have any doubts about the installation, operation or safety
of this Set Top Box, please call us.
WARNING:
1. To prevent fire or shock hazard, do not expose the system to rain
or moisture.
2. To avoid electrical shock, do not open the casing of the Set Top
Box. Refer servicing to authorized personnel only.
3. The main lead must only be replaced from a authorized service
center.
4. Any repairs or adjustments may only be performed by authorized
personnel. The warranty will become void if the user attempts to
open and repair the unit.
5. Improper intervention may interfere with the electrical safety of
the unit.
6. The company assumes no liability for any accidents suffered by
the user if the system has been opened.
CAUTION:
1. The unit operates on 70-350V AC 45/60 Hz. Check that the unit's
operating voltage is identical with your local power supply.
32
2. Your Set Top Box i s m a d e f o r m o d e r a t e temperatures.
Do not use or store the Set Top Box in hot, cold, damp or dusty
places.
3. Never place any objects on the unit and ensure that there is
a space of at least 10 cm above the unit to ensure that any
heat occurring is discharged properly.
4. To prevent fire or sh ock h azard, do no t place objects
filled with liquids, such as vases, on the Set Top Box.
5. Always insert the main lead first in Set Top Box before you
insert the plug into the mains supply.
6. Whenever you disconnect the Set Top Box from the mains
supply, remove the plug from the mains socket-outlet before
you remove from the mains connector on the rear panel of the
Set Top Box.
7. Disconnect the mains cable before cleaning the unit. For
cleaning purpose use a dry cloth and only clean the surface of
the unit.
8. Do not block the ventilation holes of the Set Top Box. Leave a
space of at least 10cm around all sides. Never install the device
in a cabinet or on a shelf where there is inadequate
ventilation. Take care that children do not insert any objects
into the ventilation slots due to danger of electric shock.