Makita 9032 Technical Information page 4

R
epair
( 3 ) After assembling arm , tighten arm cover with pan head screw M4 x 20 as illustrated in Fig. 5 C.
< 6 > Disassembling driving roller and armature
( 1 ) Take off carbon brushes. And disassemble lever 40, hex bolt M5 x 13, flat washer 5 and ring 9 after taking off
stop ring E-8. So pulley cover and arm section can be separated from motor unit. See Fig 6.
Lever 40
( 2 ) Take off bracket together with armature, by unscrewing tapping screws 4 x 25 as illustrated in Fig. 6 A.
Tapping screws 4 x 25
( 3 ) Separate driving roller from armature shaft by unscrewing
truss head screw M5 x 12 clockwise with an impact driver.
See Fig. 6B.
Fig. 5 C
Pulley cover
Ring 9
Flat washer 5
Hex bolt M5 x 13
Stop ring E-8
Armature
Pan head screw
M4 x 20
Bracket
P 4 / 8
Carbon brushes
Fig 6
Motor housing
Fig 6 A
Truss head
screw M5 x 12
Driving roller
No. 1R038
Armature Vise
Holder Set
(aluminum)
Fig 6 B