6. Check the region command listed in the bottom of this document.
7. Execute the cmd command from RUN to open up Command prompt window
8. Type " adb devices" to make sure the USB connection is OK.
You will find there is a device displayed under the " List of devices attached "
9. If your region is VSD241‐WTA‐US0, please type
" adb shell mmc_access w_region_apk en_US 64 " (Enter)
10. Process adb reboot forced‐recovery step again and update to user build image.
11. Go to the NVFlash_xxx folder and execute nvflash400_1G_ user.bat for image
update.
ViewSonic Corporation
135
Confidential - Do Not Copy
VSD241/SD-A245/CDS245