Configuring Connection To The Internet (Router Mode Only) - D-Link DAP-1150 Quick Installation Manual

DAP-1150
Configuring Connection to the Internet (Router
Mode Only)
You should configure your WAN connection in accordance with data
!
provided by your Internet service provider (ISP). Make sure that you
have obtained all necessary information prior to configuring your
connection. Otherwise contact your ISP.
PPPoE or IPoE WAN Connection
1. Go to the Net / Connections page and click the Add button.
2. In the General settings section, select a needed value from the
Connection Type drop-down list.
3. In the Physical layer section, select the value corresponding to the
LAN port of the access point (WAN) from the Physical interface
drop-down list.
4. If your ISP uses MAC address binding, enter the address registered by
your ISP upon concluding the agreement in the MAC field.
5. For Static IP connection (IPoE): fill in the IP Address, Netmask,
Gateway IP Address, and Primary DNS server fields.
6. For Dynamic IP connection (IPoE): select the Obtain an IP address
automatically and Obtain DNS server addresses automatically
checkboxes.
7. For PPPoE connection: enter authorization data provided by your ISP
(the username (login) in the PPP Username field and the password in
the Password and Password confirmation fields), or select the
Without authorization checkbox if authorization is not required.
8. If needed, fill in other fields on the page in accordance with data provided
by the ISP.
9. Click the Save button.
Quick Installation Guide
11