Prepare Walls And Floor; Countertop Requirements; Installation Procedure; Installation Of The Anti-Tip Bracket - Bosch hei80 Installation Instructions Manual

Prepare Walls and Floor
Seal any holes in the walls or floo. Remove any ob-
structions (extra electrical or gas connections, etc.) so that
range will rest against wall properly.
Countertop Requirements
Countertops must be smooth and level.
Installation Procedure
Installation of the anti-tip
bracket
WARNING
A child or adult can tip the range
over and be killed.Verify that the
anti-tip bracket is securely
installed. Ensure the anti-tip
bracket is engaged when the
range is moved.
The range can tip forward potentially causing injury and
damage if the anti-tip bracket is not installed. Do no operate
the range without the anti-tip bracket in place.
Steps to Install the Anti-Tip Bracket
,
,
,
Adjust height of range and level by rotating the
adjustable leg supports on the bottom of the range,
using a 1-1/4" wrench.
Position the bracket as shown below in the back left
corner of the installation opening, against the back wall
and the left cabinet wall. Mount the bracket using two
screws into either the floor or the base of the adjacent
cabinet. Note The mounting surface must be
secure. When mounting to the cabinet wall make sure
the screws engage the frame of the cabinet, not the
thin wall of the cabinet only. Do not use a block or
spacer to fill a gap between the anti-tip bracket and the
cabinet wall.
Secure the bracket with two screws to the floor or to
the base of the cabinet wall. Depending on the floor or
cabinet material use wood or anchorless concrete
screws (included). Concrete screws require the use of
a 3/16" masonry bit. Screws should provide fim
attachment into solid wood or flooring. Do not attempt
to anchor into drywall.
Electrical Connection
The slide in range may be connected using a electric range
cord (as specified in the Electrical Requirements section
preceeding) or using a flexible conduit electrical
connection.
Connect Electric Range Cord
4. Note: In Canada, the range is shipped from the factory
with the range cord already installed. Continue to
"Complete the installation" on page 11.For installations
other than those in Canada, connect the range cord at
the terminal block. Access the terminal block by
removing the cover in the lower left hand corner of the
range back panel.
English 8