Table of Contents
Advertisement
I Installationand GroundingInstructions I
Examine Your Oven
Unpack oven, remove all packing material and exam-
ine the oven for any damage such as dents, broken
door latches or cracks in the door. Notify dealer imme-
diately if oven is damaged. DO NOT install if oven is
damaged.
Placement of Oven
1, Oven must be placed on a flat, stable surface. For
proper operation, the even must have sufficient air
flow. Allow 3-inches (7.6 cm) of space on both sides
of the oven and 1-inch (2,5 cm) of space on top of
oven.
a. DO NOT block air vents.
If they are blocked during operation, the
oven may be overheated and damaged.
When using any cloth over the oven, the air
intake and exhaust should not be blocked.
Also should allow space on back and both
sides of oven properly.
b. DO NOT place oven near a hot, damp surface
such as a gas or electric range, or dishwasher.
c. DO NOT operate oven when room humidity is too
high.
2. This oven was manufactured for household use only.
3. This oven may be built into a wail cabinet, if desired,
by using the proper trim kit, which may be
purchased from a local dealer, Follow all installation
instructions packed with the kit.
Installation
1. DO NOT block air vents, if they are blocked during
operation, the oven may overheat, If the oven
overheats, a thermal safety device will turn the oven
off. The oven will remain inoperable until it has
coo_ed.
2. This oven was manufactured for household use only.
Grounding Instructions
This appliance must be grounded. In Ihe event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the elec-
tric current. This appliance is equipped with a cord hav-
ing a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNINGIImproper
use of the grounding plug
can result in a risk of electric shock.
Consult a qualified electrician or service person if the
grounding instructions are not completely understood,
or g doubt exists as to whether the appliance is proper-
ly grounded. It it is necessary to use an extension cord,
use only a three wire extension cord that has a three
blade grounding plug, and a three slot receptacle that
will accept the plug on the appliance. The marked rat-
ing of the extension cord should be equal to or greater
than the electrical rating of the appliance.
Power Supply
1. A short power-supply cord is provided to reduce the
hsks resulting from becoming entangled in or tripping
over a longer cord.
2. Longer cord sets or extension cords are available
and may be used if care is exerdsed in their use
3 If a long cord or extension cord is used, (1) the
marked electrical rating of the cord set or extension
cord should be at least as great as the electrical rat-
ing of the appliance, (2) the extension cord must be
a grounding-type 3-wire cord, and (3) the tonger cord
should be arranged so that it will not drape over the
counter top or tabletop where it can be pulled on by
children or tripped over accidentally.
Wiring Requirements
1. The oven must be on a SEPARATE CIRCUIT. No
other appliance should share the circuit with the
microwave oven, If it does, the branch circuit fuse
may blow, the circuit breaker may trip, or the food
may cook slower than the times recommended in
thismanual.
2. The VOLTAGE used must be the same as specified
on this microwave even (120 V, 60 Hz). Using a
higher voltage is dangerous and may result in a fire
or other incidentcausing oven damage. Using a
lower voltage will cause slow cooking. Panasonie is
NOT responsible for damage resulting from the use
of the oven with other than the specified voltage.
3 The oven must be plugged into at least a 20 AMP,
120 VOLT, 60 Hz GROUNDED OUTLET. Where a
standard two prong outlet is encountered, it is the
personal responsibility and obliga-
tion of the consumer to have it
r=='==_
replaced with a properly
grounded three-prong outlet.
TV / Radio Interference
1. Operation of the microwave oven may cause inter-
ference to your radio, TV or similar equipment,
2. When there is interference, it may be reduced or
eliminated by taking the following measures:
a. Clean door and sealing surfaces of the oven.
(See Care of Your Microwave Oven)
b. Place the radio, TV, etc. away from the
microwave oven as far as possible.
c. Use a propedy installed antenna to obtain
stronger signal reception.
Glass Tray
1, DO NOT operate the oven without Roller Ring and
GrassTray in place
2. DO NOT operate the oven without the Glass Tray
fully engaged on the drive hub. Improper cooking or
damage to the oven could result. Verify that the
Glass Tray is properly engaged and rotating by
observingits rotation when you press Start.
3. Only use the Glass Tray specifically designed for this
oven. Do not substitute any other glass tray.
4. If the Glass Tray is hot, allow to cool before cleaning
or placing in water,
5 DO NOT cook directly on the Glass Tray. Always
pJacefood in a microwave-safe dish, or on a rack set
in a microwave-safe dish
6 If food or utensil on the Glass Tray touches oven
walls, causing the tray to stop moving, the tray will
automatically rotate in the opposite direction This is
normal.
7, Glass Tray can turn in either direction.
Roller Ring
1 Roller Ring and oven floor should be cleaned fie-
quenlly to prevent excessive noise
2. Roller Ring must always be used for cooking along
with Glass Tray.
3 Always replace Roller Ring and Glass Tray in their
proper positions.
3
Advertisement
Table of Contents
