Aligning The Print Head - Canon Pixma iP6700D Quick Start Manual

Aligning the Print Head

When performing the print head alignment, you need to load paper in the auto sheet feeder.
• Always load paper in portrait orientation. Loading paper in landscape orientation can cause the
paper to be jammed.
• Cutting plain paper to 4" x 6" / 101.6 mm x 152.4 mm, 5" x 7" / 127.0 x 177.8 mm, or 2.13" x 3.39"
/ 54.0 x 86.0 mm (Credit Card) size for a trial printing can cause paper jams.
Paper support
Auto sheet feeder
Print side
1
Paper output tray
2
Cover guide
3
Pull out the paper support and paper
output tray completely as shown.
Put your fingers in the notches in either side of the paper
output tray and pull down to open it.
Be sure to use both hands to support and lower the
paper output tray.
Load the A4/Letter-sized plain paper
and align it with the cover guide on the
right side of the paper support.
You can load up to 150 sheets of plain paper (64 gsm).
Do not exceed this limit.
Slide the paper guide against the left
side of the paper stack.
Ensure that the cover guide stands when you load
paper in the auto sheet feeder.
7