JUKI MF-7800D Series Engineer's Manual page 129

Adjustment Procedure
3. Assembling the cloth chip and chain-off thread suction device
(1) Fix two tube clips
lock nuts .
(2) Fix mounting plate
that tube clips face the operator's side at the bottom face of the
table while satisfying the dimensions of the table shown in the figure.
(3) Fit waste remover body
step 2), fit muffler
and tighten it with hose clamp
4. Connecting the flexible hose
(1) First, cut flexible hose
Side A. Attach the flexible hose to cloth chip pipe (asm.)
waste remover body
respectively. At that time, make sure to remove sags.
(2) At this time, take care not to allow the flexible hose
slacken.
Then connect muffler
time, also cut the hose to an appropriate length. After connecting
the tube to them, clamp them with hose clamp
(Caution) The flexible hose
margin, however, cloth chips may remain in the middle
of the hose if the hose slackens excessively. So, do not
make the hose longer than is necessary or slacken it
excessively.
to mounting plate with screws
with (tube clip) installing wood screws
to tube clips which have been fixed in
and hose clamp to waste remover body
.
to a length required for connection on
. Then clamp them with hose clamps
on side B and reducing socket
is slightly too long to provide a
and fitting
so
,
and
,
to excessively
. At this
.
– 125 –
Results of Improper Adjustment
MC-36