Stihl FS 94 Instruction Manual page 24

English
is released: The ignition is switched on
again after the engine stops – the engine
is then ready to start.
Function of throttle set wheel
4
The throttle set wheel (4) enables the
travel of the throttle trigger to be preset
anywhere between idle and full throttle.
Turn throttle set wheel (4) in
–
direction of – to reduce throttle
trigger travel and maximum engine
speed.
Turn throttle set wheel (4) in
–
direction of + to increase throttle
trigger travel and maximum engine
speed.
It is possible to override the preset
–
stop and open the throttle wide by
pulling the throttle trigger firmly – the
preset stop remains unaffected. The
original setting is restored when the
throttle trigger is released.
22
Starting the Engine
5
Press the manual fuel pump
N
bulb (5) at least five times – even if
the bulb is filled with fuel.
Cold engine (cold start)
1.
6
2.
Turn choke knob (6) and then push
N
it in at g
Also use this setting if the engine has
been running but is still cold.
Turn throttle set wheel in direction of
–
+ as far as stop.
Hot engine (hot start)
Choke knob (6) remains in F
N
position.
Cranking
Place the unit on the ground: It must
N
rest securely on the engine support
and the deflector.
If fitted: Remove the transport guard
N
from the cutting attachment.
To reduce the risk of accidents, check
that the cutting attachment is not
touching the ground of any other
obstacles.
Make sure you have a firm footing,
N
either standing, stooping or
kneeling.
Hold the unit firmly on the ground
N
with your left hand and press down
– do not touch the throttle trigger,
lockout lever or stop switch.
NOTICE
Do not stand or kneel on the drive tube.
FS 94 R