Optimus 32-1222 Owner's Manual page 4

32-1222.fm Page 4 Tuesday, July 6, 1999 4:03 PM
3. Replace the battery compartment
cover and tighten the windscreen.
If the battery power is low, the red
BATT LOW indicator lights when the
microphone's switch is set to
(standby). Replace the battery.
STBY
AAO3201222
Warning: Dispose of old batteries
promptly and properly. Never burn or
bury them.
Caution: If you do not plan to use the
microphone for a week or more, re-
move the battery. Batteries can leak
chemicals that can damage electronic
parts.
Connecting the Receiver to
an Amplifier, Mixer, or Tape
Recorder
Connect the receiver to an amplifier,
mixer, or tape recorder using either
the receiver's or
LINE
jack.
To use the jack, connect a
LINE
shielded audio cable's phono plug to
the receiver's jack. Connect the
LINE
other end to a line-level input on your
amplifier, mixer, or tape recorder.
4
To use the
shielded audio cable's mono
phone plug to the receiver's
jack. Connect the other end to a mi-
crophone-level input on your amplifier,
or mixer, or tape recorder.
ON
AA
Connecting the Power
Adapter
The receiver operates from standard
AC power, using the supplied 12-volt
DC power adapter.
Cautions:
1. Turn off the receiver by pressing
output
AUDIO
2. Plug the adapter's barrel plug into
jack, connect a
AUDIO
• Use only the supplied adapter. If
you lose or damage this adapter,
order a replacement from your
local RadioShack store. Using
other adapters could damage the
receiver.
• Always plug the adapter into the
receiver before you plug it into the
AC outlet. Always unplug the
adapter from the outlet before you
unplug it from the receiver.
until the button is in the
POWER
outmost (off) position.
the receiver's
DC 12V
route the cord through the strain
relief.
LI N E
AU D
IO
DC 12
V
10 0m
A (M
AX )
Strain Relief
1
/ -inch
4
AUDIO
jack, then