Cruise Control* - Managing Speed - Volvo S60 2017 Owner's Manual

Cruise control* - managing speed

It is possible to activate, set and change the
stored speed.
Activating and setting the speed
To start the cruise control:
•
Press the steering wheel button for CRUISE
(without speed limiter) or
limiter).
> The cruise control symbol (6) in the com-
bined instrument panel illuminates - cruise
control is in standby mode.
To activate cruise control:
•
At the required speed - press the steering
wheel button or .
> The current speed is stored in memory and
the combined instrument panel's marking (5)
illuminates at the selected speed and the
symbol (6) changes from GREY to WHITE -
the car then follows the stored speed.
NOTE
Cruise Control cannot be enabled at speeds
below 30 km/h (20 mph).
Changing the stored speed
Stored speed is changed with short or long
presses on the or steering wheel button.
Disengaging and selecting a higher or lower gear does not involve standby mode.
3
To adjust 5 km/h (5 mph):
•
Use short presses - each press gives 5 km/h
(5 mph).
To adjust 1 km/h (1 mph):
•
Hold down the button and release it at the
required speed.
Last press made is stored in the memory.
(with speed
If speed is increased using the accelerator pedal
prior to pressing the
car's current speed when the button is pressed
that is stored.
A temporary increase in speed with the accelera-
tor pedal, e.g. during overtaking, does not affect
the cruise control setting - the car returns to the
last stored speed when the accelerator pedal is
released.
NOTE
If any of the Cruise Control buttons are held
depressed for several minutes then it is
blocked and deactivated. To be able to reacti-
vate Cruise Control, the car must be stopped
and the engine restarted.
Related information
•
Cruise control* (p. 192)
Cruise control* temporary
deactivation and standby mode
The function can be temporarily deactivated and
set in standby mode.
Temporary deactivation - standby mode
To temporarily disengage cruise control and set it
in standby mode:
•
>
/ button, then it is the
Standby mode due to driver
intervention
Cruise control is temporarily disengaged and
automatically set in standby mode if:
•
•
•
•
The driver must then regulate the speed.
A temporary increase in speed with the accelera-
tor pedal, e.g. during overtaking, does not affect
DRIVER SUPPORT
Press the steering wheel button
The combined instrument panel's
marking (5) and symbol (6) change colour
from WHITE to GREY - cruise control is tem-
porarily disengaged.
the foot brake is used
the clutch pedal is depressed for longer than
3
1 minute
the gear lever/selector is moved to N posi-
tion
the driver maintains speed higher than the
stored speed for longer than 1 minute.
* Option/accessory, for more information, see Introduction.
.
}}
193