Disassembly For Repair - Kenwood KMC-35 Service Manual

KMC-35/36
■ Main PCB removal
1. Remove the four screws, the rear case and all-round pack-
ing.
2. Lift the switch PCB and remove it from the front case.
( q )
3. Lift the upper part of the Main PCB using a pair of twee-
zers ( w ) and remove the Main PCB.
w
■ Main PCB installation procedure
1. Install the microphone holder, spacer and keytop (KMC-36
only) on the front case.
2. Tilt the Main PCB and fit the modular connector into the
front case first.
2

DISASSEMBLY FOR REPAIR

Switch PCB
q
Main PCB
3. Hold the modular connector with your fingers and move it
in the direction indicated by the arrow to install the Main
PCB onto the front case.
■ PTT knob installation procedure
1. Place the PTT knob in the front case diagonally as shown
in the figure.
2. Hold down the upper part of the PTT knob ( q ) and push
the PTT knob shaft down ( w ) to install the PTT knob onto
the front case.
■ Hot microphone modification procedure
1. Lift the jumper with a pair of tweezers or similar tool. ( q )
Note : The jumper is bonded to the board, but not strongly
fixed, so it can be detached by applying light force.
2. Cut the base of the jumper into two parts with a pair of
nippers or similar tool. ( w )
q
w
q
w