Samsung DA68-03316A User Manual page 20

COUPLER "A" COUPLER "A"
LINE OUTLET LINE OUTLET
SIDE OF SIDE OF
PURIFIER PURIFIER
PURIFIER WATER PURIFIER WATER
COUPLER COUPLER
WATER INLET WATER INLET
SIDE OF PURIFIER SIDE OF PURIFIER
Replacement Instructions
1. Shut off water supply.
2. Note the Flow direction on the filter.
3. Insert water supply tube into the inlet side of the
filter until the tube stop.
WATER SUPPLY WATER SUPPLY
INLET SIDE INLET SIDE
4. After inserting tube, put together the clip strongly.
The Clip fix the tube.
5. Turn on the water and check for leaks. If leaks
occur, repeat step 1,2,3,4. If leaks persist,
discontinue use and call your supporting dealer.
6. Flush filter for 5 minutes before use.
DA68-03316A-00.indb 20 DA68-03316A-00.indb 20
TAP TAP
90 degree 90 degree
CAUTION
Insert Locking Clip After Insert Locking Clip After
tube seated tube seated
Locking Clip Locking Clip
FLOW DIRECTION FLOW DIRECTION
PERMEAT PERMEAT
Note : You must also ensure
that the cut is square and not
at any sort of angle as this
could cause a leak
English - 20
Remove any residual matter inside
the purifi er. (Model with the purifi er)
- Open the main water tap to check whether water
is running through the water tube on the water
inlet side of the purifier.
- If water does not come out through the line,
check whether the tap is open.
- Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed.
OUTLET SIDE OF OUTLET SIDE OF
PURIFIER PURIFIER
WATER WATER
Attach the purifi er lock-clip.
- Hold the purifier lock-clip in the appropriate
position (under the sink for example) and fix it
tightly into place where to screw.
Secure the purifi er in position.
- Fix the purifier in position, as shown in the figure
on the right.
Purifier lock-clip Purifier lock-clip
PURIFIER PURIFIER
WATER LINE WATER LINE
Purifier lock-clip Purifier lock-clip
WATER TUBE WATER TUBE
PURIFIER PURIFIER
2015. 3. 10. 2015. 3. 10. 7:15 7:15