Makita 4351T Instruction Manual page 6

Lighting up the lamps
For 4351FCT only
CAUTION:
Do not look in the light or see the source of light
•
directly.
To turn on the lamp, pull the trigger. Release the trigger
to turn it off.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing saw blade
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade and/or blade holder. Failure
to do so may cause insufficient tightening of the
blade, resulting in a serious personal injury.
Do not touch the blade or the workpiece
•
immediately after
extremely hot and could burn your skin.
Tighten the saw blade securely. Failure to do so
•
may cause a serious injury.
When you remove the saw blade, be careful not to
•
hurt your fingers with the top of the blade or the tips
of workpiece.
To install the blade, open the tool opener to the position
shown in the figure.
1
008007
Keeping that situation, insert the saw blade into the
blade clamp as far as the two protrusions of the blade
can not be seen.
operation; they may
1. Tool opener
1
2
008008
Return the tool opener to its original position.
After installing, always make sure that the blade is
securely held in place by trying to pull it out.
CAUTION:
Do not open the tool opener excessively, or it may
•
cause tool damage.
To remove the blade, open the tool opener to the
position shown in the figure. Pull the saw blade out
toward the base.
1
be
008009
NOTE:
Occasionally lubricate the roller.
•
Hex wrench storage
008033
When not in use, the hex wrench can be conveniently
stored.
6
1. Blade clamp
3
2. Jig saw blade
3. Protrusions
1. Jig saw blade
1. Base
2. Hex wrench
1
2