Stopping - Husqvarna K 1270 Operator's Manual

With a warm engine:
• Make sure that the stop switch (STOP) is in the left
position.
• The correct choke/start throttle setting is obtained by
pulling the choke control to the choke position and
then pushing it in again. This only engages the start
throttle setting without any choke.
• Decompression valve: Press in the valve to reduce
the pressure in the cylinder, this is to assist starting
the power cutter. The decompression valve should
always be used when starting. The valve
automatically returns to its initial position when the
machine starts.
• Grip the front handle with your left hand. Put your right
foot on the lower section of the rear handle pressing
the machine against the ground. Pull the starter
handle with your right hand until the engine starts.
Never wrap the starter cord around your hand
• When the machine starts, press the throttle trigger to
disengage the start throttle, and the machine will idle.
24 – English
STARTING AND STOPPING
NOTICE! Pull with your right hand out the starter cord
slowly until you feel a resistance (as the starter pawls
engage) and then pull firmly and rapidly.
Do not pull the starter cord all the way out and do not let
go of the starter handle when the cord is fully extended.
This can damage the machine.
WARNING! When the engine is running
!
the exhaust contains chemicals such as
unburned hydrocarbons and carbon
monoxide. The content of the exhaust
fumes is known to cause respiratory
problems, cancer birth defects or other
reproductive harm.
Carbon monoxide is colorless and
tasteless and is always present in
exhaust fumes. The onset of carbon
monoxide poisoning is distinguished by
a slight dizziness which may or may not
be recognized by the victim. A person
may collapse and lapse into
unconsciousness with no warning if the
concentration of carbon monoxide is
sufficiently high. Since carbon monoxide
is colorless and odorless, its presence
can not be detected. Any time exhaust
odors are noticed, carbon monoxide is
present. Never use a gasoline powered
power cutter indoors or in trenches more
than 3 feet (1 meter) deep or in other
areas with poor ventilation. Ensure
proper ventilation when working in
trenches or other confined areas.

Stopping

CAUTION! The cutting blade continues to
!
rotate up to a minute after the motor has
stopped. (Blade coasting.) Make sure
that the cutting blade can rotate freely
until it is completely stopped.
Carelessness can result in serious
personal injury.
• Stop the engine by moving the stop switch (STOP) to
the right.