Cisco MDS 9000 Configuration Manual page 27
Hide thumbs
Also See for MDS 9000:
- Command reference manual (1464 pages) ,
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages)
Table of Contents
Advertisement
Chapter 2
Initial Switch Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Note
Enter the switch name: switch_name
Enter yes (yes is the default) to configure the out-of-band management configuration.
Step 10
Continue with Out-of-band (mgmt0) management configuration? (yes/no) [y]: yes
Enter the IP address for the mgmt0 interface.
a.
Mgmt0 IP address : mgmt_IP_address
b.
Enter the netmask for the mgmt0 interface in the xxx.xxx.xxx.xxx format.
Mgmt0 IP netmask : xxx.xxx.xxx.xxx
Enter yes (yes is the default) to configure the default gateway (recommended).
Step 11
Configure the default-gateway: (yes/no) [y]: yes
Enter the default gateway IP address.
Step 12
IP address of the default-gateway: default_gateway
Enter no (no is the default) to configure advanced IP options such as in-band management, static routes,
Step 13
default network, DNS, and domain name.
Configure Advanced IP options (yes/no)? [n]: no
Enter yes (yes is the default) to enable Telnet service.
Step 14
Enable the telnet service? (yes/no) [y]: yes
Enter no (no is the default) to not enable the SSH service.
Step 15
Enable the ssh service? (yes/no) [n]: no
Step 16
Enter no (no is the default) to not configure the NTP server.
Configure the ntp server? (yes/no) [n]: no
Enter noshut (shut is the default) to configure the default switch port interface to the noshut state.
Step 17
Configure default switchport interface state (shut/noshut) [shut]: noshut
Enter on (on is the default) to configure the switch port trunk mode.
Step 18
Configure default switchport trunk mode (on/off/auto) [on]: on
Enter deny (deny is the default) to configure a default zone policy configuration.
Step 19
Configure default zone policy (permit/deny) [deny]: deny
This step denies traffic flow for all members of the default zone.
Step 20
Enter yes (no is the default) to enable a full zone set distribution (refer to the Cisco MDS 9000 Family
Configuration Guide).
Enable full zoneset distribution (yes/no) [n]: yes
You see the new configuration. Review and edit the configuration that you have just entered.
OL-7765-02
The switch name is limited to 32 alphanumeric characters. The default is switch.
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide
Using the Switch Setup Utility
2-7
Advertisement
Table of Contents
