Cisco MDS 9000 Configuration Manual page 26

Using the Switch Setup Utility
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Starting kernel...
INIT: version 2.78 booting
Checking all filesystems..... done.
Loading system software
Uncompressing system image: bootflash:/m9500-sf1ek9-mz.2.1.1a.bin
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
INIT: Entering runlevel: 3
Make sure you enter the password you wish to assign for the admin username.
Step 4
---- System Admin Account Setup ----
Enter the password for "admin":
Tip
Note
Note
Enter yes to enter setup mode.
Step 5
This setup utility will guide you through the basic configuration of the system. Setup
configures only enough connectivity for management of the system.
*Note: setup is mainly used for configuring the system initially,
when no configuration is present. So setup always assumes system
defaults and not the current system configuration values.
Press Enter at anytime to skip a dialog. Use ctrl-c at anytime
to skip the remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no): yes
The switch setup utility guides you through the basic configuration process. Press Ctrl-C at any prompt
to end the configuration process.
Enter no (no is the default) to not create any additional accounts.
Step 6
Create another login account (yes/no) [n]: no
Enter no (no is the default) to not configure any read-only SNMP community strings.
Step 7
Configure read-only SNMP community string (yes/no) [n]: no
Enter no (no is the default) to not configure any read-write SNMP community strings.
Step 8
Configure read-write SNMP community string (yes/no) [n]: no
Step 9 Enter a name for the switch.
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide
2-6
If you create a password that is short and easy to decipher, then your password is rejected. Be
sure to configure a strong password. Passwords are case-sensitive. You must explicitly configure
a password that meets the requirements listed in the "Configuring User Accounts" section in the
Cisco MDS 9000 Family Configuration Guide.
If you are running the switch setup utility for the first-time, it starts automatically. If this is not
the first-time configuration, you are required to enter setup at the system prompt.
If you do not wish to answer a previously configured question, or if you wish to skip answers to
any questions, press Enter. If a default answer is not available (for example, the switch name),
the switch uses what was previously configured and skips to the next question.
Chapter 2 Initial Switch Configuration
OL-7765-02