ABB COMMANDER 150 User Manual page 19

...3.2 Set Up Level (Level 2)
A140. 5
rSt-n
H150. 2
rSt-n
L130. 8
rSt-n
O. A dJ
•1 The average value is reset automatically on power-up and can also be reset from
a digital input – see Section 4.3.4.
•2 The maximum and minimum values are reset automatically on power-up and can
also be reset from a digital input – see Section 4.3.4.
Average Value
•1
This is the mean average value of the process variable
input since the average was reset.
To reset, select
Maximum Value
•2
This is the maximum value of the process variable since
the maximum was reset.
To reset, select
Minimum Value
•2
This is the minimum value of the process variable since
the minimum was reset.
To reset , select
Offset Adjustment
An offset can be applied to the process variable input to
enable spot calibration or the removal of system errors.
1. 0
3 SET UP MODE...
– reset
rSt-Y
rSt-n – do not reset
rSt-Y then press the
rSt-Y – reset
– do not reset
rSt-n
then press the
rSt-Y
– reset
rSt-Y
– do not reset
rSt-n
then press the
rSt-Y
[±10% of engineering range]
8
key.
key.
key.
17