ABB COMMANDER 150 User Manual page 18

8
...3 SET UP MODE
...3.2 Set Up Level (Level 2)
SEC. t Ot
456789
rSt-n
PrESEt
000000
PrEdEt
999999
A140. 5
•1 Only displayed if enabled in the Configuration Level – see Section 4.3.3.
•2 The preset value must be lower than the predetermined value when counting up,
and greater than the predetermined value when counting down.
16
Secure Total
•1
The secure total is independent of the batch total value.
When 999999 or 000000 is reached, the total is reset
and then continues counting.
Total
Reset
To reset, select
Preset Batch Total
•2
This is the value the batch total is set to when it is reset.
Predetermined Batch Total
•2
When this value is reached the batch total either resets
(with wrap on) or stops (wrap off) – see Section 4.3.3.
Continued on next page.
– reset totalizer
rSt-Y
– do not reset totalizer
rSt-n
then press the
rSt-Y
[000000 to 999999]
[000000 to 999999]
key.