Change Parameters Associated Witha Zone (See Figure 8.); Change Zone Names; Figure 7 Lower-Level Menu Structure; Figure 8 Zone Parameters Menu - Motorola Spectra Service Manual

"ZONE" "MODE"
SELECT
ZONE
SELECT
"EXIT"
"SCAN"
NAME
MODE
"NAME"
Select "RADIO" to add or modify items which affect
overall radio operations (including both trunked and con-
ventional), such as the phone list, radio home mode,
etc.
Select "TST FREQ" to enter the radio test mode.
Select "CH TEST" to enter the control head diag-
nostic routine.
Select "ALIGN" to enter a limited radio alignment
routine.
The radio service software can be used to
selectively disable individual functions in order to
restrict access to certain radio parameters.
Refer to the radio service software user's manual for
information.
IV. CHANGE PARAMETERS ASSOCIATED WITH
A ZONE (See Figure 8.)
1. After selecting "ZONE" from the top level menu;
press HOME. The display changes to a zone num-
ber/name (for example, "ZONE 1"). The zone name
will be flashing to indicate that a selection is expect-
ed. Press Mode up or down to scroll through all the
zones in your radio and the "EXIT" display.
At the "EXIT" display, press Mode to repeat the
cycle, or press HOME to return to the top level menu.
Press Mode down to cycle through all the zones in
reverse order.
2. Scroll through the zones until you find the one you
wish to modify. When the zone is displayed, press
HOME to select the zone for modifications. The dis-
play now changes to "NAME."
"RADIO"
"SITE"
"HOME SEL" "STATUS"
"PHONE" "MESSAGE"
"CALL"
"SCAN" "EXIT"
Figure 7. Lower-Level Menu Structure
NOTE
NOTE
"SERVICE"
MPL
RAC
NAME
ST
"SECURE" EXIT
NAME
"LO POWER"
HOME
Figure 8. Zone Parameters Menu
By pressing Mode, you can cycle the display to
"SCAN," "EXIT" and back to "NAME." Use this
menu when you wish to edit the zone names or
zone-slaved scan lists.
V. CHANGE ZONE NAMES
Radio service software can be used to disable mode
names. This will result in all zones being shown as
"ZONE XX," where XX is the zone number. Attempt-
ing to change the zone name in the front panel will
result in a bad-key tone.
1. With "NAME" displayed, press HOME. The zone
selected is displayed with the first character flash-
ing. Follow the instructions for editing the mode
names to change the zone name.
"ALIGN"
"TST FREQ" "CH TEST"
SELECT SELECT
"EXIT"
FREQ SIGNAL
"REF OSC"
"HI POWER" "DEV"
ZONE
HOME
ZONE XX
HOME
MODE NAME
EXIT
MODE SCAN
NOTE
NOTE
"EXIT"
"EXIT"
MGXW-5804-C
MGXW-5804-C
MODE
MAEPF-22082-O
19