HP ProLiant MicroServer Generation 8 Quickspecs page 3

QuickSpecs
Standard Features
Storage Controller
Internal Storage Devices Optical Drive
Maximum Internal
Storage
Interfaces
Industry Standard
Compliance
operating system.
HPE ROM performs very early configuration of the video controller, to allow monitoring of initialization
progress via an attached monitor. If configuration or hardware errors are discovered during this early
phase of hardware initialization, suitable messages are now displayed on the connected monitor.
Additionally, these configuration or hardware errors are logged to the Integrated Management Log
(IML) to assist in diagnosis.
The Hewlett Packard Enterprise ProLiant ROM is used to configure the following:
Processor and chipset status registers
System memory, memory map, and memory initialization
System hardware configuration (Integrated PCI devices and optional PCIe cards).
Customer-specific BIOS configuration (using the HPE ROM-Based Setup Utility (RBSU).
NOTE: For further information, please refer to The Hewlett Packard Enterprise RBSU (ROM based
setup utility) user guide: http://www.hp.com/support/rbsu.
HPE Dynamic Smart Array B120i Controller
NOTE: HDD bays 1 and 2 support 6.0Gb/s SATA. HDD bays 3 and 4 support 3.0Gb/s SATA.
NOTE: Supports RAID 0/1/10 only. No FBWC support. For FBWC, a standup Smart Array Controller
card must be configured.
NOTE: For more information about the controller and its features, see the HPE Dynamic Smart Array
RAID Controller User Guide on the HPE website: (http://www.hp.com/support/DSA_RAID_UG_en).
NOTE: To configure arrays, see the Configuring Arrays on HPE Smart Array Controllers Reference
Guide on the HPE website (http://www.hp.com/support/CASAC_RG_en).
NOTE: Please see the QuickSpecs for Technical Specifications and additional information:
https://www.hpe.com/h20195/v2/gethtml.aspx?docname=c04168333
Hard Drives
Non-Hot Plug SATA
Video
HPE iLO Remote
Management Network
Port
Micro SD slot
USB 2.0 Ports
USB 3.0 Ports
Network RJ-45 (Ethernet) 2 (Port 1 shared for HPE iLO4 as optional configuration)
ACPI V2.0b Compliant
PCIe 2.0 Compliant
PXE Support
WOL Support
USB 2.0
Optional: SATA DVD-RW drive
None ship standard
16TB (4 x 4TB) 3.5" SATA
1 Rear standard video
1Gb Dedicated (default iLO4 configuration)
1 Internal
NOTE: The MicroSD slot is not a hot-pluggable device. Customers should
not attempt to plug a MicroSD card into the MicroSD slot while the server
is powered.
5 total (2 front, 2 rear, 1 internal)
2 total (2 rear)
NOTE: Functional after OS boot.
HPE ProLiant MicroServer Generation 8 (Gen8)
Page 3