HP flexfabric 5900cp Solutions Configuration Manual page 25

Parameter name/type
Upper limit of concurrent logins using
the same user name
Configure password control attributes
for the local user.
Enable broadcast suppression and set
the broadcast suppression threshold.
Enable multicast suppression and set
the multicast suppression threshold.
Enable unknown unicast suppression
and set the unknown unicast
suppression threshold.
Set the maximum number of lines to
be displayed on a screen.
Set the maximum number of concurrent
Telnet users.
Parameter value
access-limit max-user-number 16
recommended
Depends on environment
broadcast-suppression { ratio | pps
max-pps | kbps max-kbps }
multicast-suppression { ratio | pps
max-pps | kbps max-kbps }
unicast-suppression { ratio | pps
max-pps | kbps max-kbps }
screen-length screen-length
aaa session-limit telnet max-sessions
default=16
Remarks
By default, the number of concurrent
logins is not limited for the local user.
This command takes effect only when
local accounting is configured for the
local user. It does not apply to FTP,
SFTP, or SCP users who do not support
accounting.
Configure the maximum login attempts
and the action to take if there is a login
failure: password-control login-attempt
login-times [ exceed { lock | lock-time
time | unlock } ]
By default, broadcast traffic is allowed
to pass through an interface.
By default, multicast traffic is allowed
to pass through an interface.
By default, unknown unicast traffic is
allowed to pass through an interface.
By default, a screen displays a
maximum of 24 lines. A value of 0
disables pausing between screens of
output.
Changing this setting does not affect
online users. If the current number of
online Telnet users is equal to or greater
than the new setting, no additional
Telnet users can log in until online users
log out.
25