Assembling The Pedestal - Panasonic TH-42PX600U, TH-50PX600U, TX-58PX600U Operating Instructions Manual

Warning
Do not disassemble or modify the pedestal.
•
Otherwise the unit may fall over and become damaged, and personal injury may result.
Caution
Do not use any television or displays other than those given in this manual.
•
Otherwise the unit may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
•
If you use the pedestal while it is physically damaged, personal injury may result. Contact your nearest Panasonic
Dealer immediately.
During setting-up, make sure that all screws are securely tightened.
•
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough to
support the plasma television, and it might fall over and become damaged, and personal injury may result.
Use the accessory fall-prevention brackets to secure the plasma television.
•
If the unit is knocked or children climb onto the pedestal with the Plasma TV installed, the plasma television may
fall over and personal injury may result.
Two or more people are required to install and remove the television.
•
If two people are not present, the television may be dropped, and personal injury may result.
Accessories for pedestal assembly
Assembly screw
A B
(4)
(for 42˝ and 50˝) M5 x 18
(for 58˝) M5 x 25
1

Assembling the pedestal

Using the four assembly screws
illustration below.
Pole
a
( )
Align the stamped marks.
2
Setting-up
Television unit
Pedestal
Attaching the pedestal to the plasma television
Assembly screw Pole (2)
C
(4)
M5 x 65
, securely fasten the left and right poles to the base, as shown in the
A
Front
A
Pole
B
Label
Base (1)
D
Pole
b
( )
Pole
Align the stamped marks.
* Carry out work on a horizontal and level surface.
Lift the television unit above the pedestal
base, with the back of the display unit on
the same side as the Label. Then align the
holes in the television unit with the poles of
the pedestal and lower the television unit into
place.
B
Use the assembly screws
fasten securely.
Rear
Band (2)
E
Front
(M5 x 65) to
B
7