FAQs
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in
some cases, despite good reception of analogue programmes.
Unable to receive
signals with a
high-performance
aerial
Sound is unusual
An error message
appears
"Control with HDMI"
function does not work
TV goes into
"Standby mode"
An error message
appears
38
Problem
Problem
•
Install an aerial individually for the TV and VCR
(or use a splitter).
TV
Aerial
Input
terminal
VCR
•
Set the sound setting of the connected equipment
to "2ch L.PCM".
•
Check the "HDMI1 input" setting in the Sound menu.
(p. 16)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 34)
•
Contact the authorized Service Centre.
•
Switch the TV on again with the equipment on.
•
Set "Control with HDMI" to "Off", then set to "On" again.
(p. 27)
•
The sleep function is activated.
•
The TV enters "Standby mode" about 30 min.
after broadcasting ends.
•
Follow the message's instructions.
•
If the problem persists, contact the authorized
Service Centre.
Actions
Actions
(Individual aerial)
Splitter
Aerial Output
Aerial Input
Aerial Output
(Individual aerial)