Panasonic Viera TH-42PX45EH Operating Instructions Manual page 19

(DVB mode only)
Insert the CI module (optional)
This TV receiver works only Pay TV modules
complying with CI standard.
Caution
•
Turn Off the On / Off switch on the TV whenever
inserting or removing the CI module.
•
If a view card and a card reader come as a set,
fi rst insert the card reader, then insert the view
card into the card reader.
Select "Common Interface Module"
DVB System Setup
Access
Common Interface Module
Preferred Language Setting
Time Zone Auto
Display Timeout 3 seconds
Follow the on-screen instructions
example:
select, go
Coloured characters
Select "Preferred Language Setting"
DVB System Setup
Common Interface Module
Preferred Language Setting Access
Time Zone Auto
3 seconds
Display Timeout
Set the language (Audio, Subtitles, Teletext)
Select "Time Zone" and set the time
DVB System Setup
Common Interface Module
Preferred Language Setting
Time Zone Auto
3 seconds
Display Timeout
Select "Display Timeout" and set the time
DVB System Setup
Common Interface Module
Preferred Language Setting
Time Zone Auto
3 seconds
Display Timeout
Update the software at appropriate intervals to ensure that the TV's performance and functions are updated.
For details (p. 32)
Select "Auto Update Search in Standby" and then select "On" or "Off"
DVB System Update
On
Auto Update Search in Standby
System Update Search Now
Software Licence
To update immediately
Select "System Update Search Now"
displays a corresponding message if any
•
The message might be the notifi cation beforehand. In this case, the schedule information (the date that the
new version can be used) will appear.
View software licence information
Select "Software Licence"
next
OK
red green yellow blue
next
select
set
select
set
select
set
select
Searches for an update (for several min.) and
OK
Display
CI slot
Insert or
remove
squarely
CI module
•
For more details, see the manual of the CI
module, or check with the broadcaster.
•
Normally pay-TV services will appear without
following steps 1 and 2 (shown for information only).
•
On-screen operation guide may not correspond
to the remote control buttons.
•
This is the initial language setting for Audio,
Subtitles (p. 11) and Teletext.
Auto : The time data will be adjusted according to
your area automatically.
Others : The time data will be corrected based on
GMT.
•
0 (No display) to 10 sec. in 1-sec. increments
•
Information banner (p. 10)
•
On: Automatically performs a search in standby
at 3:00 AM and 5:00 AM and downloads an
update, if any
Downloads (for about 20 min.)
(Rear of the TV)
19