Details Of Error Display - Pioneer XR-A550MD Service Manual

XR-A550MD
QQ
3 7 63 1515 0

7.2.2 DETAILS OF ERROR DISPLAY

Error Display
÷ DEFECT occurred 10 times continuously during REC-PLAY.
Can't REC
÷ Recordable cluster became 0 since DEFECT occurred during
REC-PLAY.
÷ Address is unreadable. REC state can not be set for 20 seconds
even after try again.
÷ Determined as follows according to the channel status of the
Can't COPY
signals input from D-IN during REC-PAUSE or REC-PLAY.
1. Other than audio
2. Other than consumer use
3. Copy NG due to inversion of COPY bit of CD
÷ The following occurred for digital signal input from D-IN during
D-IN UNLOCK
REC-PAUSE, REC-PLAY, or CD FUNC playback
1. Digital IN PLL unlocked.
2. Locked at other than FS = 32, 44.1 and 48 kHz.
÷ No area for registering music number and character information
TOC FULL
during REC-PLAY (music name, disc number, etc.)
÷ FTNO > LTNO.
UTOC R ERROR
÷ FTNO ≠ 0 or 1.
÷ UTOC recorded on DISC could not be read.
÷ Start address > End address.
UTOC ERR A
TE
L 13942296513 ÷ Any one data of UTOC 0 to 4 has looped.
UTOC ERR L
÷ Data not for audio is recorded for TNO track mode currently
NOT AUDIO
selected.
÷ Data called MINI of system ID written in ASCII codes in TOC is
UNKNOWN
incorrect.
DISC
÷ Disc type written in TOC is not pre-mastered MD, recording MD,
or hybrid MD.
÷ No recordable space when attempted to set REC-PAUSE.
DISC FULL
÷ Disc only for playback was loaded when attempted to set REC-
PREMASTERED
PAUSE or edit.
÷ Attempted to record or edit even through REC-proof knob of
PROTECTED
disc for recording was in the REC-proof state.
÷ Attempted to edit track with write-protect according to information
on UTOC.
÷ Editing conditions were not satisfied for each editing function.
Can' t EDIT
÷ Temperature inside unit (MD unit) was too high due to fault.
TEMP OVER
÷ Data read was incorrect or could not be read properly.
DISC ERR
÷ Error occurred during music data recording and recording could
not be performed correctly.
www
.
102
http://www.xiaoyu163.com
Details of Error
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
÷ Check if there are scratches, dusts, fingerprints, or black
spots on disc. Check if disc fluctuates eccentrically or
moves up and down largely.
÷ Check if CD is copy-proof. (Example: CD-R, etc.)
÷ Check if D-IN signal line is normal.
÷ Replace with recording/playback disc with space for
registering UTOC.
÷ Replace with other discs to check if UTOC data is normal.
÷ Replace with other discs to check if UTOC data is normal.
Q Q
3 ÷ Replace with other discs to check if UTOC data is normal. 6 7 1 3 1 5
÷ Select other TNO or replace with other discs.
÷ Disc is outside specifications. Replace with different disc
and check.
÷ Replace with different disc with recording space.
÷ Disc is for playback only. Replace with disc for recording.
÷ Track attempted to be edited is write-protected. Try again
with different track.
÷ Restore the REC-proof knob and try again.
÷ Operating method is wrong. Try again using correct
method.
÷ Check according to TROUBLESHOOTING.
÷ Faulty TOC or UTOC data or scratch on disc. Replaced
with other discs.
co
.
9 4 2 8
Measure
0 5 8 2 9 9 4 2 8
m
9 9
9 9