Master/Slave Operation; Xlr Connection - ROHS Hyper Bar 252 User Manual

www.divinelighting.com
"FL00": white color strobe（FL00-FL15 speed adjustable）
 Operation
Pressing "Menu" repeatedly cycles through the available modes. The unit will retain settings
even after the power has been disconnected.
Description of built-in programs（Pr- -）
Pr00:red;
Pr03:red+green
Pr06:red+green+blue
Pr09: program 3
Pr12: program 6
Pr15: Comprehensive program 1-8;
Note:Pr7--- Pr15 Can change the content Of SP，SP0-SP15.
 Master/Slave
Master：Units are always set in Master mode (i.e. outputting DMX signal that mirrors
their own operation) unless they are set in DMX mode. Signal lines longer than 60 meters
or 20 fixtures should utilize a signal amplifier.
Slave：Daisychain all the slave units to the master unit using DMX cable. Set all
slaves to DMX mode and address them to channel 1 (A001).
Note: This product uses input and output power cord 0.75 m㎡copper core wire
that allows the units to be powered together. When using 220V AC, link no more than
35 units together. Using 115V AC, link no more than 20 lights! ! !
 XLR cable：(DMX Cable)
XLR/DMX connections are connected male to female, as shown below:
pin 1:ground,pin 2: negative signal, pin 3: positive signal
Pr01:green
Pr04:red+blue
Pr07:program 1
Pr10: program 4
Pr13: program 7

8. Master/Slave Operation

9. XLR Cable Connections
Pr02:blue
Pr05:green+blue
Pr08:program 2
Pr11: program 5
Pr14: program 8
5
Hyper Bar 252 v1.0