Manual Feeder M - Pitney Bowes Relay 1000 Operator's Manual

3 ● Run a Job

Manual Feeder M

Relay 1000 models have a Manual Feeder M that allows you to feed
stapled sets of up to three sheets of 20 pound bond (80 g/m
are fed by hand, one set at a time, for processing by the system. When
you use the manual feeder, the system automatically turns off both
sheet feeders. You can, however, use the manual feeder along with the
envelope, insert, fold-only and sealer selections to run a variety of jobs
manually.
To use the manual feeder:
1. Set up the system as you normally would for the job you are running.
The selections shown by the indicators for Sheet Feeders A1 and/
or A2 are ignored by the system. All other selections apply to the
manual job.
2. Feed one staple set, face down
and bottom edge first, gently
into the manual feed slot. The
system automatically starts
and draws the set from you.
The system processes the set
and ejects it into the stacker in
the usual manner.
NOTES:
• Be sure to feed the set into the system squarely and gently. If you feed
it in at an angle or with force, a poor fold or jam could result.
• The first set will not seal even if you set up the system to do so. This
"trial" feature allows you to inspect the processed job to make sure
that all pieces were inserted correctly and that the address appears in
the envelope.
3-16
CAUTION! Feeding more than three sheets in a set
may damage your system.
). The sets
2
SV63176 RevB