Related Manuals for R-Can RO-QC3
Summary of Contents for R-Can RO-QC3
- Page 1 R.O. Installation & Service Guide Part #: RO-QC3, RO-QC4, RO-QC4P System Conforms to ANSI/NSF Standards 58 for Performance Class (see data sheet) Please read this manual carefully before attempting installation.
- Page 2 Recommended Filter and Membrane Replacement Schedule. Filters should be changed every six to twelve months depending on the quality of the feed water supply.. The R-Can Advanced Water Products installation should comply with all local laws and regulations. Manufacturer recommends a TDS test every six months.
-
Page 3: Starting Your Installation
Starting Your Installation STEP 1: Drilling the Faucet Hole STEP 1: Drilling the Faucet Hole and light pressure until the porcelain has been penetrated to the material underneath. The product water faucet may be installed on any fl at surface at least 2” in diameter. Check the underside of Stainless Steel Sink the location for interference. - Page 4 Tapping into the Cold Water Line STEP 2: Shut Off the Water STEP 3: Mounting the Tank Ball Valve STEP 3: Mounting the Tank Ball Valve Locate the water shut-off valve for the cold water feed line that you have chosen to use for the supply. Accidentally hooking up the system to the hot supply line will permanently damage the membrane (See Conditions for operation).
- Page 5 fi rmly. To remove a tube, push in the collet and pull out Important: Remove the black protective cap from the the tube. mem brane before screwing in place. Model PreFilter Carbon Membrane PostFilter RO-QC3 AWP5621 RO-QCM50 AWP5633 RO-QC4 AWP5605 AWP5633 RO-QCM50 AWP5633...
-
Page 6: System And Faucet Diagrams
This will al low storage tank pressure to in crease suffi eiently for the ice mak er so le noid to op er ate prop er ly. Leave the ball valve in the closed po si tion un til the tank is full after start up procedure is completed. R-CAN System R-CAN System (RO-QC4) - Page 7 R-CAN System R-CAN System (RO-QC4P)
- Page 8 R-CAN System R-CAN System (RO-QC3)
-
Page 9: Troubleshooting And Maintenance
Troubleshooting & Maintenance Do Not Use the First Two Reservoirs of Water. Do Not Use the First Two Reservoirs of Water. Allow the res er voir to fi ll for 4-6 hours. Dis pense this wa ter to drain. This process removes the factory installed sanitizing solution from the entire system and sends it to the drain. -
Page 10: Limited Warranty
Limited War ran ty R-CAN warranties the reverse osmosis system to be free from defects in ma te ri als and work man ship under normal use within the operating pa ram e ters listed below. For a period of three years from the date of purchase, we will repair or replace any part of the reverse osmosis system with the exception of the fi...