Elvox 46216.310E Installation And Operation Manual page 10

3 Connections
Alarm Connection:
- Alarm Input: There is one independent alarm input port (ALM-IN) and one grounding port (ALM-GND).There are no type
requirements for sensors. NO and NC are both available. Join the grounding ends of the sensor and the camera and then
connect the signal cable of the sensor to the alarm input port of the camera.
- Alarm Output: There is 1 CH alarm output including COM and NO connections.
Loosen the screws in the alarm output port. Then insert the signal wires of the alarm output devices into the port of NO and
COM separately. Finally tighten the screws. Some of the external alarm output devices need the power supply.
RS 485 Connection:
You can control the speed dome by RS485 interfaces.
Network Cable Connection:
8
Network cables
Router
Network cables
Modem
Mic IN
Headphone
12 Vdc
Internet
Monitor
ALM-COM
ALM-NO
ALM-IN
ALM-GND
RS485T+
RS485T-
Network
cables
Computer
EN