Swisscom Aton CL114 User Manual page 5

Please note:
◆
Never expose the telephone to the influence of heat sources, direct sunlight or other electrical devices.
◆
Protect your Aton from moisture, dust, corrosive liquids and vapours.
Connecting the base station
¤
First connect the mains adapter
¤
Then connect the telephone jack
cables into the cable ducts.
Please note:
◆
The mains adapter must always be connected, as the
phone will not operate without mains connection.
◆
Only use the mains adapter and phone cord supplied.
Pin connections on telephone cables can vary.
Connecting the charging cradle (if included)
2
Setting up the handset for use
The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries and closing the battery cover
Warning
Use only the rechargeable recommended batteries (
batteries as this could result in significant health risks and personal injury. For example, the batteries could explode.
The phone could also malfunction or be damaged as a result of using batteries that are not of the recommended
type.
¤
Insert the batteries
with the polarity in the
correct direction.
The polarity is indicated in
the battery compartment.
1
.
2
and insert the
¤
Connect the flat plug from the power
1
supply .
¤
Plug the mains adapter into the plug
1
2
socket .
If you need to disconnect the plug from the
charging cradle, press the release button
and disconnect the plug
¢
¤
Insert the battery cover from
the top.
¤
Then slide the cover upwards
until it clicks into place.
3
2 1
4
.
page 13), i.e., never use conventional (non-rechargeable)
To open the battery cover, for instance to
replace the batteries:
¤
Reach into the notch at the top of the
cover and slide the cover down-
wards.
1 1
4
3
3