Surround Parameters - Behringer ddx3216 Instructions Manual

o 105
o 106
o 107
If TX/RX is active, the DDX3216 sends the corresponding parameter or
receives it as a MIDI SysEx file.
•
additional new update features:
o 100 markers (previously 10) as well as an EMPTY indicator in case
marker storage is empty. You can recall the marker menu via
MMC/MIDI > MACHINE CONTROL > LOCATE (also see ch. 13.2).
o TIME COUNTER RELATIVE (display page MMC/MIDI > SETUP, also
see ch 13.1) can now be activated at the MIDI setup page (on/off).
You're dealing with an SMPTE timecode offset, i.e. there is no time
delay. If you for example have a continuous time code on an external
multitrack tape over several songs, you can set TIME COUNTER
RELATIVE to ON at the start position of the song (or song segment)
you wish to modify. This way, the actual current locator value is
assigned 00:00:00:00 on the DDX3216 as its new time position. All
locator operations such as forward, return, play etc. still remain in sync
with one another; it is only the time code display that is relative to the
actual tape position.

4. SURROUND PARAMETERS

Only a few (however effective) parameters are needed to control the surround option:
•
Send signal level in the selected channel (surround source) can be adjusted to
the surround outputs by using LEVEL (-
•
You can use the PRE or POST switch to send the signal to the surround
outputs independently from the stereo mix (PRE), or you can additionally
control the signal's volume via the channel fader (POST), together with the
signal portion for the conventional stereo mix.
surround divergence
surround subwoofer pre/post
surround subwoofer volume
to +12 dB).
∞
4