Troubleshooting (Faq) - Asus SD433 User Manual

3.4

Troubleshooting (FAQ)

Problem
LED indicator is not ON
The LED indicator lights red and
there is no screen image
Screen image is too light or dark
Screen image bounces or a wave
pattern is present in the image
Screen image has color defects
(white does not look white)
No sound or sound is low
The remote control does not work • Battery may be weak or exhausted.
ASUS Display SD433
Possible Solution
• Press the Power button ( ) to check if the display
is turned on.
• Check if the power cable is properly connected to
the display and the power outlet.
• Check if the display and the computer are turned on.
• Make sure the signal cable is properly connected the
display and the computer.
• Inspect the signal cable and make sure none of the
pins are bent.
• Connect the computer with another available display
to check if the computer is properly working.
• Adjust the Contrast and Brightness settings via
OSD.
• Make sure the signal cable is properly connected to
the display and the computer.
• Move electrical devices that may cause electrical
interference.
• Inspect the signal cable and make sure that none of
the pins are bent.
• Perform Reset via OSD.
• Select one of the available color temperatures
(Color Temp.) via OSD. If the Color Temp. setting
is set to User Mode, you can manually adjust the
Red Gain/Green Gain/Blue Gain/Red Offset/
GreenOffset/Blue Offset setting.
• Make sure the audio cable is properly connected to
the display.
• Adjust the volume settings of both your display and
computer.
• Make sure the computer sound card driver is
properly installed and activated.
• Make sure that you correctly inserted the battery into
the remote control.
• The remote control is out of range. Move closer to
the display and point the remote control directly at
the remote control sensor on the front of the display
with an angle of 15°.
• Make sure there are no obstacles between the
remote control and the remote control sensor on the
front of the display.
3-11