ProForm 525 CT User Manual page 12

8. With the help of a second person, hold the con-
sole assembly near the Handrails (84) (only one
side is shown).
See the inset drawing. Connect the Upright
Wire (81) to the console wire. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Then, remove the wire tie from
the Upright Wire.
9. Set the console assembly on the Handrails (84).
Be careful not to pinch any wires. Insert the
excess Upright Wire (81) into the Right
Upright (90).
Attach the console assembly with the four 1/4" x
1/2" Screws (2) removed in step 7 and four 1/4"
Star Washers (26); do not tighten the Screws
yet.
8
Console
Assembly
Console
Wire
84
9
Console Assembly
84
81
26
2
90
12
81
Console
Wire
Wire
Tie
81
26
2
84