Pioneer DJD-707 Service Manual page 115

5
1. How to rewrite the program for the system control microcomputer
1 With the DJM-707's power off, connect the DJM-707 and a PC via the special device by connecting it to the connector for
rewriting the program for the system control microcomputer.
2 Turn on the DJM-707.
3 Start up [FLASH.exe], the software for rewriting, on the PC.
4 Assign "3068F.inf" to "Device selection Flash memory block information file."
5 Assign 5 sec to "Timeout duration."
6 Assign "Boot mode" to "Mode selection."
7 Click on "Set".
8 If "Set to Boot mode and restart by resetting" is displayed, click on "OK".
9 The rewriting control program is transferred in 5 seconds.
0 When program transfer is finished, the display in the window disappears.
Select "WRITE" at the upper left of the menu bar.
- After clicking on Reference, select "mixer_707_xxxx.mot" (or PD3453x8.mot)
for "Filename."
= Assign "00000000" to "Start address."
~ Assign "0003FFFF" to "End address."
! Assign "0" to "Offset."
@ Click on "OK".
# The system control computer program is transferred in 2 min 30 sec.
$ When program transfer is finished, the display in the window disappears.
Select File on the menu bar then Exit to exit the program.
% Turn off the DJM-707.
^ Disconnect the special device from the DJM-707.
• After rewriting the system control microcomputer, make the setting for the noncontact fader (see 7.1.1 "Service mode").
5
6
DJM-707
6
7
• Operating screen
5
6
7
8
9
0
PD3453x8.mot
=
00000000
~
0003FFFF
!
0
#
$
7
8
A
3068F.INF
3062FA.INF
3067S,INF
4
3068F.INF
B
C
D
-
@
E
F
115
8