Safety Information; Installation - Grindmaster 810 Operator's Manual

Safety Information

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
For your safety and the safety of others, read all warnings and the operator's manual before installing or using
the product.
DANGER:
This term warns the user of imminent hazard that will result in serious injury or death.
WARNING:
This term refers to a potential hazard or unsafe practice, which could result in serious injury or
death.
CAUTION:
This term refers to a potential hazard or unsafe practice, which could result in minor or moderate
injury.
NOTICE:
This term refers to information that needs special attention or must be fully understood.
•Product must be attached to a three wire 120V 15 AMP receptacle (export units - 230V 16 AMP).
•Do not deform plug or cord.
•Follow national and local electrical codes.
•Do not use near combustibles.
•Use only on a circuit load that is properly protected and capable of the rated load.
•Always unplug unit from power supply before servicing or cleaning.
FAILURE TO COMPLY RISKS PERSONAL INJURY, SHOCK HAZARD, FIRE, OR DAMAGE TO EQUIPMENT.
Personal injury hazard. Keep fingers, hands, and foreign objects out of hopper or chute opening.
Model 890T must be bolted to the counter to prevent possible bodily injury from overturning.
Never connect to an overloaded circuit or to an extension cord, otherwise serious damage to the motor may
result.

Installation

CAUTION:
Risk of bodily injury due to tipping.
Use care when installing Model 890T.
NOTICE:
It is essential that full voltage and amperage
always be available as it takes full power to grind
coffee.
Please read this manual before operating the grinder.
1. Carefully remove grinder from carton.
2. Place grinder in position on shelf, counter
or other flat surface.
3. (Model 890T only). Using (4) provided 5/16"-
18 x 1 1/2" bolts, washers, and nuts, attach
grinder securely to counter.
4. Plug grinder into the specified power
source. (Check rating plate on back of unit
for voltage and amperage requirements.)
Do not use an extension cord.
5. Fill hopper with whole bean coffee.
6. Grind a small amount of whole bean coffee
800 Series Coffee Grinders
Important Safety Information
WARNING
CAUTION
NOTICE
following
described in this manual
7. If there is any problem, consult the
Troubleshooting Guide in this manual, (also
on back of grinder.)
If you need help, call GMCW Technical Service
Department for help, (502) 425-4776 or (800) 695-4500
(USA & Canada only) 8 AM - 6 PM EST.
Prior authorization must be obtained from GMCW for
all warranty claims.
Grindmaster ®
operating instructions as
3