Advertisement
Determine the length of tubing you will need from the filter
head INLET to the adapter by holding the tubing in place.
Do not kink the tubing as this will impede water flow. Cut
the desired length necessary for connec on making sure to
cut tubing straight with razor knife or tube cu er.
6. Insert the tubing from the adapter (figure 2) to the INLET
side of the filter head. (ARROW POINTING INWARD
TOWARD THE CENTER) SEE PAGE 5‐ "Using Push‐In
Fi ngs."
7. Locate the Male threaded adapter. Connect this adapter
to the cold water hose disconnected in Step 4.
DO NOT OVERTIGHTEN.
8. Determine the length of the remaining tubing required
to connect from the filter head OUTLET to the adapter by
holding the tubing in place. Cut to the desired length.
9. Insert the tubing into the adapter (SEE PAGE 5‐ "Using
Push‐In Fi ngs." Then insert the tubing into the OUTLET
side of the filter head (ARROW POINTING AWAY FROM
CENTER).
FIGURE 3
Male Adapter
Advertisement
