D-Link DWL-AG660 Manual page 19

Using the Configuration Utility (continued)
Frequency:
Select the network fre-
quency from these op-
tions: Auto; b 2.4GHz; b/g
2.4GHz; or a 5GHz.
Super A/G:
Enable or Disable.
XR Mode:
Enable or Disable.
Starting Ad-Hoc Network:
If you are configuring an
Ad-Hoc network, select
2.4GHz or 5GHz.
Ad-Hoc Channel:
Select Auto or 1-11.
Profile IP Settings:
You can Enable or Disable the IP Settings portion of your profile here. If you
select Disable you will need to configure the IP address information each
time you connect to a network. If you select Enable you will maintain the
same IP address information each time you connect to a network.
Power Mode:
Disable - Saves no power.
Fast Save - Moderate power-saving.
Max Save - Saves the most power.
Data Packet Parameter:
Set the Fragmentation Threshold and the RTS Threshold. Please see below.
Fragmentation Threshold:
This value should remain at its default setting of 2346. If you experience a high
packet error rate, you may slightly increase your fragmentation threshold within
the value range of 256 to 2346. Setting the fragmentation threshold too low may
result in poor performance.
RTS Threshold:
This value should remain at its default setting of 2346. If inconsistent data flow
is a problem, only a minor modification should be made.
Advanced
Launch Utility on Startup:
Select Enable or Disable.
19