Operating Your Breville Product - Breville RM-800CPXL Instruction Booklet

OPERATING YOUR BREVILLE PRODUCT

PAGE HEADER.....
1. Ensure the Citrus Press is correctly
assembled and a glass or jug is placed
under the Juice Spout before juicing
commences.
2. Cut the citrus fruit in half by cutting
across the fruit segments, rather than
across the tip ends, to ensure more
effi cient juicing.
NOTE
Some fruits, such as lemons and
tangelos, have knobbly tip ends which
require trimming for better contact
with the Fruit Dome.
12
3. Plug the power cord into a 110/120V
power outlet, then press ON/OFF button
to ON.
4. Place a citrus fruit half, cut side down,
onto the Juice Cone and push down
lightly onto the spikes.
5. Grasp the Soft Grip Handle and slowly
lower the Juice Press Arm and press
down fi rmly until the Fruit Dome is in
contact with the fruit skin. The motor
will automatically start and the Juicing
Cone will begin to rotate. The juice will
be extracted from the fruit and fl ow
through the Juice Spout into the glass.
The pulp and seeds will collect in the
Stainless Steel Filter.
OPERATING YOUR BREVILLE PRODUCT
6. The Citrus Press juices very quickly
so each fruit half will be juiced in a
few seconds. To automatically stop the
motor, lift the Juice Press Arm up and
backwards to its extended position.
7. Remove the used fruit from the Juicing
Cone. Empty excess pulp and seeds from
Stainless Steel Filter as required. Repeat
Steps 3-7 to continue juicing.
NOTE
The Stainless Steel Filter should be
emptied when full with pulp and seeds.
The Filter can be emptied during
juicing by turning the Citrus Press OFF
at the ON/OFF button and carefully
removing the Juicing Cone and Filter.
Clean and replace Stainless Steel Filter
and Juicing Cone before continuing to
juice. Do not allow the Stainless Steel
Filter to overfi ll as this may prevent
correct operation or damage the unit.
13