Specifications Bluetooth V3.0 Bluetooth Version SUPPORT: HSP, HFP, A2DP and AVRCP Effective range 10 meters Music: Up to 12 hours Working time Talk: Up to 13 hours Standby time Up to 360 hours Input DC: 5V/130mA Charging time Approx 3 hours Microphone Bulid‐in Rechargable Micro USB cable How to use 1) Switching on / off headset Function Operation LED indicator Voice Prompt Press the MFB button for 3 Switch seconds, and release it till Power on Blue LED blink 2 times. on the blue LED is quickly blinking twice. Press the MFB button for 3 Switch ...
Page 3
Function Operation LED indicator Voice Prompt Make sure the headset is off. Press and hold MFB Enter pairing Blue & Red LEDs button for 5 seconds, and Pairing mode blink alternatively. release it until the blue & red LEDs blinking. B. Pairing the headset with Bluetooth mobile phone Please keep the headset and mobile phone in the range of 1 meter when pairing. • Make the headset enter into pairing mode. • Start the Bluetooth function of mobile phone and search the Bluetooth devices. • After searched, select “ BH‐100 ” in the Bluetooth device list. According to indication, enter password or PIN No:”0000”, and press the key of” Yes” • or “confirmed”. ( it depends on the Bluetooth device setting ) 3) Making calls with the headset Function Status of headset Operation Redial last Standby mode Short press MFB twice quickly number Volume up Conversation mode Slide up and hold MFB key Volume ...
Page 4
4) Playing music When the headset connects with the mobile phone or Bluetooth transmitter , you can enjoy music through headset wirelessly. Status of Function Operation headset Pause Playing music Short press MFB Play Pausing Short press MFB Last song Playing music Short slide up MFB key Next song Playing music Short slide down MFB key Volume up Playing music Slide up and hold MFB key Volume down Playing music Slide down and hold MFB key LED indicator Multi‐function buttons Micro USB Charging port 5) LED indication for battery Charging. LED indicator Status of the headset Red LED is on Charging Blue LED is on Finish charging 4 ...
Page 5
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.