Connecting The Gps Antenna; Removing The Unit - JVC KW-V820BT Instruction Manual

CONNECTION/INSTALLATION
❏ Connecting the GPS antenna
Connect the GPS antenna (5) to the GPS terminal.
• To install the GPS antenna, fix the metal plate
(6) firmly on the dashboard, then place the GPS
antenna (5) on the metal plate (6).
– Clean the dashboard or other surface
beforehand.
– Install the GPS antenna (5) inside of the car, as
horizontally as possible to allow easy reception
of the GPS satellite signals.
– You can bend the metal plate (6) to conform to
a curved surface, if necessary.
5
6
62
• Depending on the type of car, reception of the
GPS satellite signals might not be possible with an
internal installation.
• Install this GPS antenna in an area away from any
antennas that are used with CB radios or satellite
televisions.
• The GPS antenna should be installed at a position
at least 30 cm from mobile phone or other
transmitting antennas.
• The above types of communication may interfere
with signals from the GPS satellite.
• Painting the GPS antenna with (metallic) paint
may cause reduced performance.

Removing the unit

❏ Removing the trim plate
1
Engage the catch pins on the extraction
key (3) and remove the two locks on the
lower part. Lower the frame and pull it
forward.
5
2
• The frame can be removed from the top side in
❏ Removing the unit
1
2
2
3
• Be careful to avoid injury from the catch pins on
Remove from the upper two catches.
the same manner.
Remove the trim plate. (See the left
column.)
Insert the two extraction keys (3), then
pull them as illustrated so that the unit can
be removed.
3
the extraction key.