Ribao CS-600A Operation Instructions Manual page 9

CS-600A Operation Instructions V1.1
Note ： If batch No.≠0, when it
achieves, the motor stops and the
display shows as right picture. It blinks
to display the first channel that
achieves, blinking
channel also achieves. After noting
down, press START/STOPKey, it displays the next channel that achieves.
When there are no other channel achieving the batch quantity, it displays
normally. Press START/STOP Key, the machine starts to work again.
Note：As it is a rail sorter, when batch number is achieved, the motor will
stop, but there are still some coins in the passage, and these coins finally roll
into the drawer. The machine will display the actually counted number.
Batch setting procedure:
·Press CLR to clear to Zero;
·+1000、+100、+10、+1 keys are for batch number setting:
①+1000 is 1000, +100 is 100, +10 is 10, +1 is 1;
②One press increase the digit by 1. e.g. press +1 key once is 1,
double press is 2;
·Press
and
After setting is OK, exit as follows;
·Press BAT key to exit and enter into total quantity display mode;
·Press START/STOP key to exit and enter into standard mode.
Value setting:
·Keep pressing VAL key and turn on
the power to enter into value setting
mode.
means aother
to switch channels.
Page 9 of 16