Table of Contents
Advertisement
Connecting to a PictBridge-compliant Printer
By connecting the camera directly to a
printer supporting PictBridge via the USB
connection cable (supplied), you can select
the pictures to be printed or start printing
on the LCD monitor.
Set the print settings such as print quality
on the printer beforehand. (Read the printer
operating instructions.)
A: USB connection cable (supplied)
B: AC adaptor (DMW-AC5; optional)
• Turn off the camera before inserting or
removing the cable for the AC adaptor
(DMW-AC5; optional).
Connecting to a PC or Printer
1 Turn the camera on and then set
[USB MODE] on the [SETUP]
menu to [PictBridge (PTP)]. (P92)
2 Turn on the printer.
3 Connect the camera to a printer
via the USB connection cable A
(supplied).
• Connect the USB connection cable with
the [
the [DIGITAL] socket.
• Hold the USB connection cable at C
and insert straight in and take straight
out.
AV OUT
When the DPOF
Print is not set.
DIGITAL
When the DPOF
Print is set. (P82)
DC IN
• It may take time to print some pictures.
Therefore, use a battery with sufficient
battery power (P13) or the AC adaptor
(DMW-AC5; optional) when you connect
to a printer.
• If the remaining battery power becomes
low during communication, the battery
indication turns red and blinks (P13) and
the alarm beeps. In this case, stop the
communication at once.
• Disconnect the USB connection cable
after printing.
• Do not use any other USB connection
cables except the supplied one.
• For printing the age in [BABY] (P59) in
scene mode, print from a PC using the
software [LUMIX Simple Viewer] in the
CD-ROM (supplied). For details, refer to
the separate operating instructions for PC
connection.
] mark facing the [2] mark on
Select [SINGLE
PICTURE]. (P96)
Select [DPOF
PICTURE]. (P97)
95
VQT0S74
Advertisement
Table of Contents
