Connecting To A Pictbridge-Compliant Printer - Panasonic LUMIX DMC-FX8EB Operating Instructions Manual

Connecting to a PictBridge-compliant Printer

By connecting the camera directly to a
printer supporting PictBridge via the USB
connection cable (supplied), you can select
the pictures to be printed or start printing
on the LCD monitor.
Set the print settings such as print quality
on the printer beforehand. (Read the printer
operating instructions.)
A: USB connection cable (supplied)
B: AC adaptor (DMW-AC5; optional)
• For using the AC adaptor (DMW-AC5;
optional), turn the camera off before the
connection.
88
VQT0R45
Connecting to a PC or Printer
1 Turn the camera on and then set
[USB MODE] on the [SETUP]
menu to [PictBridge (PTP)]. (P85)
2 Turn on the printer.
3 Connect the camera to a printer
via the USB connection cable A
(supplied).
• Connect the USB connection cable with
the [
the [DIGITAL] socket.
• Hold the plug C to push into or pull out.
When the DPOF
Print is not set.
AV OUT
When the DPOF
Print is set. (P76)
DIGITAL
DC IN
• It may take time to print some pictures.
Therefore, use a battery with sufficient
battery power (P14) or the AC adaptor
(DMW-AC5; optional) when you connect
to a printer.
• If the remaining battery power becomes
low during communication, the battery
indication turns red and blinks (P14) and
the alarm beeps. In this case, stop the
communication at once.
• Disconnect the USB connection cable
after printing.
• Do not use any other USB connection
cables except the supplied one.
• For printing the age in [BABY] in the
scene modes (P54), print from a PC using
the software [LUMIX Simple Viewer] in the
CD-ROM (supplied). For details, refer to
the separate operating instructions for PC
connection.
] mark facing the [2] mark on
Select [SINGLE
PICTURE]. (P89)
Select [DPOF
PICTURE]. (P90)