Panasonic Lumix DMC-FZ30PP Operating Instructions Manual page 120

• If the remaining battery power is
exhausted during communication, the
recorded data may be damaged. When
you connect the camera to the PC, use a
battery with sufficient battery power (P13)
or the AC adaptor (DMW-CAC1; optional).
• If the remaining battery power becomes
low during communication, the power
indicator blinks (P13) and the alarm
beeps. In this case, stop the
communication at once.
• While [ACCESS] is being displayed, do
not disconnect the USB connection cable.
• When the OS of your PC is Windows
2000 and you connect the camera to
the PC with the USB connection cable,
do not replace the card with the
camera connected to the PC. The
information in the card may be
damaged. Make sure to disconnect the
USB connection cable beforehand
when you replace the card. For details,
refer to the separate operating
instructions for PC connection.
• Do not use any other USB connection
cables except the supplied one.
• Also refer to the operating instructions of
the PC.
∫ PictBridge (PTP) setting
Even if you set the [USB MODE] to
[PictBridge (PTP)], you can connect to the
PC only when the OS is Windows XP
Home Edition, Windows XP Professional or
Mac OS X.
• You can only load pictures from the
camera and cannot write them on the card
or delete them.
• When there are 1000 or more pictures on
a card, the pictures may not be imported.
120
VQT0R81
Connecting to a PC or Printer