Maytag CRE9800C User Manual page 7

Clock Pad Setting the Clock and Timer
Use this pad to set the time-of-day elock. For Clock
instructions to do this, see below.
To set the time-of-day clock:
You may also press this pad to recall the current time of
day. For example, if the timer is counting dowa in the 1. Press the CLOCK pad once. The words "Set Time"
display, press the CLOCK pad to return the current will flash in the displa>:
time to the display. The timer will continue to count "2. Set the correct time of day' using the • and • pads.
down and a signal will sound when the time expires.
• Tu change the time by one minute, press either
Cook Time/Oven Stop Pads pad once,
These pads are nsed to program the oven to start and • To change the time in increments of 10 mbmtes,
stop mltomatically, either immediately or at a later time. press and hold either pad.
For detailed in}brmation on using Programmed Oven When the power is first supplied to the range or if there
Operations, see pages 10-11. Ires been a power fiailure, the display u4ll flash. Follow
Self Clean Pad (select models)
above instructions to set the clock. The clock time
cannot be changed when the oven is set _br a cook or
This pad is pressed to set the oven for a self-clean cycle, self-clean (select models) operation. Cancel the
See pages 12-13 }'or detailed in[brmation on the self- operation to set the dock.
clean _)atnre.
Press the CLOCK pad to recall the time of day when
Broil Pad another ftmction is displayed.
Use this pad to select broil. Two heat selections are Timer
available fbr broiling--Hi and Lo. See page 10 tbr more
broiling information.
To set the timer:
1. Press the TIMER pall once. Tile words "Set Timer"
Oven Temp Pad will }lash in the display.
The oven temperature is set by pressing this pad anti '2. Set the desired time using the • and • pads.
the • or • pad. Additional baking and roasting
in}brmation can be found on page 9. • Press either pad once to change the time by 1
minute (if the Timer is set for up to 1 hour), ,5
minutes (if the Timer is set for over 1 hour), or 10
minutes (if the Timer is set for over 2 honrs).
• Press and hold either pad to change the time in 5
minute or 10 minute increments, depending upon
the time set in the display:
The TIMEB can be set from 1 minnte (0HB:01) up to 9
honrs and 50 minutes (9 HI:l:50).
The timing operation will start automatically. Colons
will flash in the display to indicate a timing operation.
One long continuous beep will signal the end of the
timing operation and "End" will briefly appear in the
displa}. The time of &LY will automatically reappear in
the displ_): The TIMER pad does not control the oven.
To eanceh Press the TIMEZ pad and hold for 3
seconds. The time of day" will reappear after a slight
delay.
PAGE 6